ID 原文 译文
10604 在该定义基础上给出一个SIFE构造方法,然后抽象为一般表达式,使得SIFE的特性在决策排序问题中更加适用。 On the basis of the definition is given a SIFE constructor, then the abstract is a regular expression, and makes the characteristics of SIFE is more applicable in the decision-making scheduling problems.
10605 通过算例分析,表明该方法的正确性,与其他直觉模糊熵构造方法比较,说明该方法可以克服存在的局限性。 Through example analysis, show that the method is correct, compared with other intuitionistic fuzzy entropy method, shows that the method can overcome the limitations of existence.
10606 针对平动调制下的进动锥体锥顶及锥底滑动型散射源微多普勒提取问题,提出一种利用微多普勒曲线交叉点频移信息完成平动补偿并利用正交匹配追踪(orthogonal matching pursuit,OMP)提取微多普勒的方法。 For translation under the modulation of precession cone cone top and the bottom of the cone type sliding scattering source micro-doppler extraction problem, put forward a kind of micro doppler curve intersection frequency shift and use the information to complete the translation compensation orthogonal matching pursuit (orthogonal matching pursuit, OMP) extract micro-doppler method.
10607 根据进动锥体散射源微多普勒变化规律建立回波模型,引入二次型平动速度调制项,发现微多普勒曲线交叉点处的瞬时频移是由剩余平动引起的。 ‭According to the precession cone scattering source micro-doppler variation echo model is set up, the introduction of quadratic translational velocity modulation, found the micro-doppler curve intersections of instantaneous frequency shift is caused by the residual translation.
10608 利用Harris-Laplace角点检测获取时频图中微多普勒曲线交叉点信息,通过最小二乘参数辨识得到剩余平动参数;‭ ‭Harris - Laplace corner detection is used to collect the time-frequency diagram micro-doppler curve intersection information, remaining translation parameters is obtained by least squares parameter identification; ‭
10609 针对平动补偿后锥体散射源微动特性构建回波信号原子集,利用OMP稀疏分解提取各散射源的微动信息。 For translational compensation after the cone scattering source micromotion characteristics build atomic set echo signal, using the OMP sparse decomposition from the micro scattering source of information. ‭
10610 仿真验证了所提方法的有效性。 The simulation to verify the effectiveness of the proposed method.
10611 研究了具有动态特性的多响应稳健参数设计问题,分析了响应变量往往具有偏度特征的情况,提出了基于多元偏正态分布与响应曲面法相结合的动态多响应稳健优化模型。 Study the dynamic characteristics of response more robust parameter design problems, analysis of the characteristics of the response variables can often be of skewness, was proposed based on multiple skewed normal distribution with response surface method in combination with dynamic response more robust optimization model.
10612 该模型不仅考虑了动态多响应之间的相关性,而且也考虑了尺度与偏度对动态多响应系统最优性与稳健性的影响。 This model not only considers the dynamic response of the correlation between more, but also considers the scale and partial degrees of dynamic response the optimality and the robustness of the system.
10613 首先,利用非参数检验方法判断在信号因子不同水平下的各响应变量所服从的分布类型; First of all, using the method of nonparametric test to judge the signal factor under different levels of the response variables by the distribution of types;